
Tips for converting older Beatzille presets to latest version
---------------------------------------------

For this latest version, the envelope triggering behaviour for the LFOs and the sequencer was fixed.
If a preset used an LFO as trigger source for an envelope, it may now behave differently, or even be completely silent. It is however the correct behaviour now, so some presets may need to be adjusted accordingly.

What changed:
1) Envelopes with LFO as trigger source will not use the note gate as an initial trigger anymore, it will only react to an upwards zerocrossing of the LFO's phase. Before, the envelope would react to "LFO plus Gate", now it will only react to the LFO.

2) Gate lengths derived from the LFO phase are now correct, so depending on your LFO settings, gate length may be different to what it was. This is also what can now cause presets to be silent if trigger signals are now too short and don't trigger an envelope.

How to fix:
1) If the envelope now triggers later than expected and you need that initial envelope trigger on gate, you can either adjust the phase of the triggering LFO accordingly and move the trigger closer to the note press, or you can try to combine the envelope with a free ramp module in a multiplex and use the combine signal to modulate the target that before only had the envelope as its source.

2) If the preset is silent, then the LFO that trigger the envelope has its "Wave" parameter at zero. Turn it up a bit until you find a value that does the trick. In general, adjust Wave and Phase until you find a triggering behaviour that works for the preset.

